System and Network Management

Hi all, does anyone know how to block an incoming number (DID) destined for a station. I know we can block if through a vector using vrt but not sure about direct to st.

thanks

If you know the number you are trying to block - you can try this:
http://www.aucommunity.com/showthread.php?t=12699
>mike

This link is dead now. At least I can't get to it.

In Reply to Michael Goodwin:

If you know the number you are trying to block - you can try this:
http://www.aucommunity.com/showthread.php?t=12699
>mike

David

David,

 

Here you go:

 

Create soft-number extension. And then map it to an off-pbx-station via the Off-pbx-telephone station mapping.
on the off-pbx-telephone screen :
Station Extension : - soft number you created
Application : Ec500
Dial Prefix : 1
Phone number : number you want to restrict
Trunk Selection : ars
Config set : 1

Mapping mode : Origination
On the station form, make the cor level have a FRL of 0 (thus restricting any outbound calling) and the Calling Party Restriction: origination
It's been a while since i did this , but this should be all you need.
>mike

I can confirm that Mike's instructions work.

 

It's a simple clean way to block calls from a specific ANI regardless of what DID number it's calling on your switch.

Hi all, does anyone know how to block an incoming number (DID) destined for a station. I know we can block if through a vector using vrt but not sure about direct to st.

thanks
You are trying to prevent a station from receiving call on its DID?

or are you trying to block calls from a certain number?

If the former: Just do
cha inc

look around in that section. You can do something like point the DID to a receptionist, or a fake number/drop the call.
If the latter, follow the link by the other poster.