Arslan,
would this procedure work for you? Not too sure since i can only find info for server edition.
joe
At a command prompt:
at
OK
at-debug
<IPOffice Manager Version 0.2>
Wed 26/2/2014 10:27:58, Hello>
updatelan
Current LAN1: ipaddr: 192.168.42.1 mask: 255.255.255.0 (LAN port)
Current LAN2: ipaddr: 128.75.0.100 mask: 255.255.255.0 (WAN port)
Enter which lan interface (lan1 or lan2):
lan1
(or hit enter to leave unchanged)
Enter IP address (a.b.c.d):
10.10.10.1
Enter IP mask (a.b.c.d):
255.255.255.0
Add default gateway (yes or no)?
10.10.10.254
Start WriteConfig at f7e0969c, savemode SaveNormal, writetype ToFlash
Start WriteConfig at f7e0969c, savemode SaveNormal, writetype ToFile
:
:
Configuration has been saved.
Reboot now (yes or no)?
no
(enter to 'yes' to reboot system immediately)
Issue the 'reboot' command later.
Wed 26/2/2014 10:28:51, Hello>
Check LAN port status with the following command:
Wed 26/2/2014 10:33:23, Hello>
lanstatus
LAN1 is connected (negotiated) at 100Mb full duplex
LAN2 is not connected
------------------------------
joe foley
telecom engineer
Fiserv, Inc.
Lake Mary FL
------------------------------
Original Message:
Sent: 11-20-2020 08:39 AM
From: Arslan Ali
Subject: IP Office - Changing IP Addresses
HI,
I am required to change IP addresses to IPO Version 11 system, this is a IP500 V2 controller unit system and not a server edition.
Please let me know, what steps I would need to change the IPs.
Phones are using IPO DHCP services.
------------------------------
Arslan Ali
UC Consultant
Vodafone
------------------------------